Horizontal Deflection Past Questions
Year: 2019
School: Federal University of Technology, Owerri
Department: Engineering
Course Code: ACE308
Topics: Structures theory, truss, truss parameters, trusses analysis, warren steel truss, bending moment, radial shear, normal thrust, Warren steel truss, horizontal deflection, maximum shear
Petroleum production engineering 2
Year: 2020
School: Federal University of Technology, Owerri
Department: Engineering
Course Code: PET405
Topics: Petroleum production engineering, surface production operations, horizontal separator, vertical separator, operating temperature, separator coefficient, operating pressure, commercial absorbents, gas flow rate, gas specific gravity, operating line pressure, gas inlet temperature, emulsion formation
Year: 2020
School: Federal University of Technology, Owerri
Department: Engineering
Course Code: PTE503
Topics: Polymer science, ideal polymer solution, dilatometer, crystallization kinetics, horizontal dilatometer, ideal polymer solutions, Floy-Higgins theory, cohesive energy density, Huggin's equation, freezing point curves
Strength of materials 2016,2017
Year: 2017
School: Federal University of Technology, Owerri
Department: Engineering
Course Code: ENG305
Topics: Shear stress, force, load, normal stress, stress, factor of safety, modulus of elasticity, modulus of rigidity, mohr's circle, beams, cantilever, deflection, deformation, flexural rigidity, columns
REINFORCED CONCRETE DESIGN 2-2012-2018
Year: 2018
School: Federal University of Technology, Owerri
Department: Engineering
Course Code: STE518
Topics: column, beam, floor, shear, deflection, reinforcement, retaining wall, punching shear, yield line method, flat slab, slab, cantilever, dead load, preliminary design, bearing pressure analysis, stem wall design, stem wall reinforcement, axial load, unaxial moment, slender column
Year: 2020
School: Federal University of Technology, Owerri
Department: Engineering
Course Code: ENG305
Topics: uniaxial stress, biaxial stress, theory of columns, deflection of beams, bending stress, shear force, bending moment, torsion.column, beams
Year: 2020
School: Federal University of Technology, Owerri
Department: Engineering
Course Code: ENG305
Topics: Shear Force, Bending Moment, Torsion, Theory of Columns, Deflection of Beams, Axial and Flexural Bending Stress, Strength of materials
Strength of materials 1 Laboratory
Year: 2019
School: University of Nigeria, Nsukka
Department: Engineering
Course Code: CVE212
Topics: Strength of materials, deflection, tensile strain, shear strain, Modulus of rigidity
Departments
Administration, Social and Management science
Agriculture and Veterinary Medicine
Arts and Humanities
Education
Engineering
General studies
Law
Medical, Pharmaceutical and Health science
Science and Technology